Transport, Packaging And Storage - WIKA A2G-50 Mode D'emploi

5. Transport, packaging ... / 6. Commissioning, operation

5. Transport, packaging and storage

5.1 Transport
Check the differential pressure transmitter for any damage that may
have been caused during transportation. Obvious damage must be
reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during trans-
port (e.g. change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -20 ... +70 °C
Protect the instruments from moisture and dust.
6. Commissioning, operation
Installation and mechanical connection
Protect measuring instruments from contamination, high temperature
■
changes and vibrations
In order to avoid any additional heating, the instruments must not be
■
exposed to direct solar irradiation while in operation.
The differential pressure transmitter must be screw-fitted on a
■
suitable vertical surface. The instrument has to be mounted horizon-
tally using the enclosed mounting screws.
WIKA operating instructions air2guide model A2G-50
GB
9