Changing The Filter Cartridges - Watts OneFlow OFPSYS Manuel D'installation, D'utilisation Et D'entretien

Diagram A
Diagram C
Diagram E
CLOSE
Diagram G
OPEN

Changing the Filter Cartridges:

Diagram B
1. Turn off the inlet and outlet valves on the system's supply and outlet
2. Use the Multifunction Tool (Item 6) to release air from the system. This
3. Use Multifunction Tool (Item 6) to unscrew OneFlow
4. Remove Outlet Connector (Item 8) from top of OneFlow
Diagram D
5. Use Multifunction Tool (Item 6) to remove OneFlow
6. Remove the Sediment/Carbon (Item 9) from the OneFlow
7. Remove new Sediment/Carbon cartridge from packaging and place
8. Insert OneFlow
Diagram F
9. Insert Outlet Connector (Item 8) into outlet port and secure back on top
10. Place Head Assembly back onto OneFlow
DO NOT OVER TIGHTEN
11. Close the pressure relief valve by tightening in a counterclockwise
12. Turn on the inlet and outlet valves on the system's supply and outlet
13. Open a downstream cold water faucet to flush any air from the
Diagram H
The system is now ready for operation.
1. Where influent water pressure will at any time exceed 500 kPa (70psi) a
2. Product performance is dependent upon influent water quality.
3. The system must be installed and maintained in accordance with the
4. Please ensure all O-rings are well lubricated and clean from foreign
5
lines.
is done by taking the tool and unscrewing the Pressure Relief Valve
(Item 5) – refer Diagram F.
(Item 7) counterclockwise and remove from the OneFlow
shown in Diagram G.
Reduction (TAC) Cartridge – refer Diagram D.
(TAC) cartridge (Item 10) from the Sediment/Carbon Cartridge (Item 9)
as shown in Diagram H.
hand.
carefully inside the OneFlow + Housing as shown in Diagram B.
®
+ Scale Reduction (TAC) cartridge back into the center
®
of the Sediment/Carbon cartridge making sure that it is sealed correctly
as shown in Diagram C.
of the OneFlow ® + Scale Reduction cartridge as shown in Diagram D.
multifunction tool tighten by screwing the Head Assembly clockwise as
shown in Diagram E.
direction as shown in Diagram F.
lines and check for leaks.
plumbing system.
NOTICE
suitable pressure limiting valve must be installed.
manufacturer's instructions including replacement of the filter cartridges.
particles.
+ Head Assembly
®
+ Housing as
®
+ Scale
®
+ Scale reduction
®
+ Housing by
®
+ Housing and using the
®