Exit Button; For Use Of Remote Controller - Marantz SC-7S1 Mode D'emploi

5. Name and funtion
Remote controller
TRIM MODE
a
f
BALANCED
h LINE 1
TAPE
a Trim Mode
Button to switch to Trim mode for trim adjustment.
s Exit button
Button to finish Trim mode after Trim adjustment.
d ATT (Attenuation) button
Button to attenuate at one touch.
f Trim-A L/M
(Trim A Channel up/down) button
Button to fine-tune the output level of A ch by Trim adjust-
ment.
g Trim-B L/M
(Trim B Channel up/down) button
Button to fine-tune the output level of B ch by Trim adjust-
ment.
h Input selector button
Button to select input source.
j Volume L/M
(Volume up/down button)
Button to adjust volume.
14
s
EXIT ATT
d
g
A TRIM B
SACD/CD
LINE 2 j
VOLUME
RC-7S1SC
I For use of Remote controller
G
Loading batteries
Before using the supplied remote control unit for the first
time, load the batteries in the remote control unit. The
batteries provided are used to verify the operations of the
remote control unit only.
1
Remove the battery cover which is found on the back
side of the remote control unit.
2
Load the two new size "AAA" batteries inside the battery
compartment while taking care to align their polarities
correctly with the polarity markings (
with ).
3
Push the cover on the back side in the direction of the
arrow to close.
G
Operatable range of Remote controller
Operate the remote control unit (RC-7S1SC) within a dis-
tance of approx. 5 m from the infrared signal reception
window (remote sensor) on the front of the SC-7S1.
Remote control operation may not be possible if the re-
mote control unit's transmitter is not pointing in the direc-
tion of the remote sensor or if there is an obstruction be-
tween the transmitter and the remote sensor.
Approx. 5m
60°
G
Caution
Do not allow direct sunlight, an inverter fluorescent light
or other strong source of light to shine onto the player's
infrared signal reception window (remote sensor). Other-
wise, the operation of the remote control unit may be dis-
abled.
Bear in mind that operating the remote control unit may
cause other devices operated by infrared rays to be op-
erated by mistake.
The remote control unit cannot be operated if the space
between the controller and the player's remote sensor is
obstructed.
Do not place any objects on top of the remote control
unit. Doing so may cause one or more buttons to be held
down which will cause the batteries to run down.
with and