Backlight - Briteq BT-150LS Mode D'emploi

ENGLISH OPERATION MANUAL
Sound Sense
Used to set the sensitivity of the internal microphone
 Press the MENU button until "Sound Sense" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select a value between "0" (very low sensitivity) and "100" (high sensitivity).
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Pan Inversion
Normal: Panning movement is not inversed.
Pan inversion: Panning movement is inversed
 Press the MENU button until "Pan Inverse" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "No" (normal) or "Yes" (pan inversion) mode.
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Tilt Inversion
Normal: Tilt movement is not inversed.
Tilt inversion: tilt movement is inversed
 Press the MENU button until "Tilt Inverse" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "No" (normal) or "Yes" (tilt inversion) mode.
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.

Backlight

Backlight on: display is always lit.
Backlight off: display is dark when not used.
 Press the MENU button until the display shows "Back Light".
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select "On" (display always lit) or "Off" (display dark when not used).
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Focus Adjust
Used to help you adjusting the focus of the rotating gobos.
 Press the MENU button until the display shows "Focus Adjust".
 Press the ENTER button so the unit goes to the "tilt 90°" position.
 Press the ENTER button so the unit goes to the "pan 0°" position.
 Press the ENTER button so the unit goes to the "pan 90°" position.
 Press the ENTER button so the unit goes to the "pan 180°" position.
 Press the ENTER button so the unit goes to the "pan 270°" position.
In the Previous 5 steps you are able to adjust the focus with the UP/DOWN buttons on the unit (the display
shows the current focus status).
Attention: please note that you can only set an "average focus" for all 5 positions, so it is not possible to set
the focus perfectly sharp for all directions.
 To go back to the functions press the MENU button.
 To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
®
BRITEQ 6/69 BT-150LS