Briteq BT-150LS Mode D'emploi page 10

ENGLISH
 Done!
Remark: You can connect a CA-8 or RF-8 remote controller to the master unit if you want to have more
control over the master/slave operation
Remark2: if there's no output, please make sure to set the first unit in master mode and set the blackout
mode to "M/S" and Sound State to "On" (see previous chapter)
Electrical installation in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality balanced cable.
 Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
Pin layout XLR-5pin:
(+) ~ Pins4+5 not used.
 To prevent strange behavior of the light effects, due to interferences, you must use
a 90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won't work!
 Make sure that all units are connected to the mains.
 Each light effect in the chain needs to have its proper starting address so it knows which commands
from the controller it has to decode. In the next section you will learn how to set the DMX addresses.
 HOW TO SET THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
DMX-CONFIGURATION OF BT-150LS IN 14CH MODE:
CHANNEL VALUE
1
2
3
4
5
6
7
®
BRITEQ
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal
Pan
000 - 255
Pan Fine (Least significant bit)
000 - 255
Tilt
000 - 255
Tilt Fine (Least significant bit)
000 - 255
Pan / Tilt Speed (000 = fast ~ 255 = slow)
000 - 255
Dimmer (0 to 100%)
000 - 255
Strobe / Shutter effect
000 - 007 Shutter closed (no output)
008 - 015 Shutter open
016 - 131 Strobe 1 (slow → fast)
132 - 139 Shutter open
140 - 181 Strobe 2: slow open / instant close (slow → fast)
182 - 189 Shutter open
190 - 231 Strobe 3: instant open / slow close (slow → fast)
232 - 239 Shutter open
FUNCTION
8/69
OPERATION MANUAL
BT-150LS