Briteq BT-150LS Mode D'emploi page 7

ENGLISH
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Slave Mode
Used to make the slave unit work in opposite to the
master or to work in complete sync.
 Press the MENU button until "Slave Mode" is shown
on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select Slave1 (normal)
or Slave2 (inverted show) mode.
 Once the mode is selected, press the ENTER button
to save it.
To go back to the main menu without any change
press the MENU button shortly.
To exit the programming mode and to store the new
settings in the memory: press the MENU button for
about 2 seconds.
Blackout Mode
With this option you can select how the projector
should behave when the DMX-signal is lost or not
connected.
 M/S mode (master/slave mode): when no
DMX-signal is detected, the projector starts
working in standalone mode. The internal
programs will be triggered to the rhythm of the
music by the built-in microphone.
 HOLD: when no DMX-signal is detected, the
unit freezes with the latest DMX values received
and waits for the DMX-signal.
 BLACKOUT: when no DMX-signal is detected,
the unit goes in blackout and waits for the DMX-
signal.
 Press the MENU button until "Black Out" is shown
on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select one of the
available modes.
 Once the mode is selected, press the ENTER button
to save it.
To go back to the main menu without any change
press the MENU button shortly.
To exit the programming mode and to store the new
settings in the memory: press the MENU button for
about 2 seconds.
Sound State
The unit works to rhythm of the beat when used in
standalone or master/slave mode
 Press the MENU button until "Sound State" is shown
on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "On" or "Off"
mode.
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
®
BRITEQ 5/69
OPERATION MANUAL
BT-150LS