Load The Photo Tray - HP Photosmart B8500 Série Guide De L'utilisateur

Chapter 1
TIP: If you are using letterhead, insert the top of the page first with the print side down.
5. Slide the paper-width guide inward until it stops at the edge of the paper.
NOTE: Make sure the paper stack is no higher than the paper-width guide.
6. Push in the main tray, if extended, to the edge of the paper stack.
7. Lower the photo and output trays together, and then extend the output tray.

Load the photo tray

You can load up to 13 x 18 cm (5 x 7 inch) photo paper into the photo tray of the HP Photosmart. For the best results,
use HP Advanced Photo Paper.
To load the photo tray
1. Raise the output tray.
2. Slide the paper-width guide to its outermost position.
3. Insert the stack of photo paper into the photo tray with the short edge forward and the print side down, sliding it
in until it stops.
TIP: Load tabbed photo paper so that the tabs feed in last.
6 HP Photosmart overview