Shutdown And Startup Problems - Fujitsu LIFEBOOK S762 Guide D'utilisation

Problem
The batteries seem to discharge
too quickly.
(continued)

Shutdown and Startup Problems

The Suspend/Resume button does
not work.
System powers up and displays
power on info, but doesn't load
the OS.
An error message is displayed on
the screen during the notebook
(boot) sequence.
Your notebook appears to change
setup parameters when you start
it.
Possible Cause
The brightness is turned all
the way up.
Battery is old or was exposed
to high temperatures.
The batteries are too hot or
too cold.
There may be application
conflict
Suspend/Resume button is
disabled.
Internal hard drive was not
detected.
The boot settings of the setup
utility are not compatible
with your configuration.
You have a secured system
requiring a password to load
your operating system.
Power On Self Test (POST) has
detected a problem.
BIOS setup changes were not
saved when made and you
exited the setup utility.
The BIOS CMOS hold-up bat-
tery has failed.
Possible Solutions
Turn down the brightness adjustment. The higher the brightness the more
power your display uses.
Replace the batteries.
Restore the notebook to normal operating temperature. Battery charging icon
will flash when battery is outside of operating range.
Close all applications and try the button again.
Enable the button by going to the Control Panel -> Power Options Properties.
Select "Choose what the power button does" option.
Use the BIOS setup utility or Primary Master submenu, located within the Main
menu, to try to auto detect the internal hard drive.
Set the operating source by pressing the [ESC] key while the Fujitsu logo is on
screen or use the [F2] key and enter the setup utility and adjust the source set-
See "BIOS Setup Utility" on page 51.
tings from the Boot menu.
Make sure you have the right password. Enter the setup utility and verify the
Security settings and modify them as accordingly.
page 51.
See the Power On Self Test (POST) messages to determine the meaning and
severity of the problem. Not all messages are errors; some are simply status indi-
See "Power On Self Test Messages" on page 96.
cators.
Make sure you select Save Changes And Exit when exiting the BIOS setup utility.
Contact your support representative for repairs. This is not a user serviceable part
but has a normal life of 3 to 5 years.
93 - Troubleshooting
See "BIOS Setup Utility" on