Shut down your notebook and disconnect the AC adapter.
2
Orient your system as shown in Figure 27.
3
Push the spring-loaded battery latch away from the battery and hold it in place.
4
Push the battery lock to the right; this will unlock the battery.
5
Lift the battery out of the battery bay at the battery lift point (Figure 28) at the rear center of the battery.
6
Align a new battery into the bay, and press it down so that the latch clicks into place.
7
Push the right battery latch to the left.
8
Plug in the AC adapter and turn the power on.
9
Hot-swapping Batteries
To hot-swap batteries in your battery bay follow these easy steps:
B
E SURE TO PLUG IN AN
THE BATTERY IS BEING REPLACED
Plug an AC Adapter into the system and connect it to a power outlet.
1
Follow steps 3 through 8 in "Cold Swapping Batteries".
2
I
L
F THE
ITHIUM ION BATTERY CONNECTOR IS NOT FULLY SEATED
AC A
DAPTER PRIOR TO REMOVING THE BATTERY
. I
AC A
F YOU DO NOT USE AN
61 - Lithium ion Battery
. T
HERE IS NO BRIDGE BATTERY PRESENT TO SUPPORT THE SYSTEM WHILE
DAPTER YOU WILL LOSE ANY UNSAVED FILES
,
YOU MAY NOT BE ABLE TO USE YOUR NOTEBOOK OR CHARGE YOUR BATTERY
.
.