Starting The Robot - Amibot PURE LASER Manuel D'utilisation

EN
Operating the robot
Inserting the water tank
When the water tank is inserted, the robot can mop hard floors. Clip
it to the back of the robot, which automatically detects the tank. The
robot is ready to start its mopping cycle.
When the robot is turned on for its cleaning cycle, the automatic
pump in the water tank is activated to clean hard floors.
NOTES:
• You can regulate the water tank's water flow intensity via the remote control
(see page 8).
• Do not use the water tank on rugs or carpets.
• You must remove the water tank from the robot before charging.

Starting the robot

After attaching the dustbin or water tank, switch the robot
on. Wait a few seconds to let it start up, then press the power
button on the robot or the AUTO button on the remote control.
The robot starts its cleaning cycle in AUTO mode.
16