Cleaning The Hepa Filter - AmazonBasics B0716T5FW2 Mode D'emploi

• Place the filter back into the cover and slide it back in.

Cleaning the HEPA Filter

• Lift the exhaust grid to remove it.
• Take out the HEPA filter
• Rinse the filter under cold water.
• Dry it afterwards.
• Refit it to its original position.
• Reinstall the exhaust grid until it clicks in place.
NOTICE
Troubleshooting
Problem
The appliance does not start.
Weak suction power.
Motor is abnormally noisy.
12
9
.
Never use the appliance without filters installed. This can
cause power loss or damage to the appliance.
Solution
• Connect the power plug properly.
• Check if the electrical outlet is powered.
• Check if the on/off switch is on.
• Check if the flexible hose, extension tube or
any of the accessories are obstructed.
• Remove and clean the filters.
• Stop using the appliance immediately.
• Check if the hose, tube or any of the
accessories are obstructed.
• Remove the obstruction.
• If the noise continues, power off the appliance
and disconnect the power plug.
• Contact your service agents.
6