Installing The Appliance; Transportation, Unpacking; Cleaning; Placement - AEG A 75100GA3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB

Installing the appliance

Transportation, unpacking

It isrecommended to deliver the appliance in
original packaging, in vertical position considering
the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape, which ensure the parts not to
move in the appliance.
Wash the inside of the appliance using lukewarm water and
mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy
consumption and proper operation of the appliance. When
placing, take into consideration that it is practical to
operate the appliance between ambient temperature limits
according to the climate class that is given in the chart
below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
increasing temperature in the freezer or increasing energy
consumption.
When placing the appliance ensure that it stands level. This
can be achieved by two adjustable feet (1) at the bottom
40

Instructions for the Installer

Ambient temperature

+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
in front. 1-1 piece of distance washers (2) are accessories
of the adjustable feet. If levelling the appliance requires,
these washers can be removed.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appliance
has to be stood near a cooker take these minimum
distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cm since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.

Publicité

Table des Matières
loading

Table des Matières