Closing The Door; Replacing The Lamp; Installation - Electrolux ERF4014AOW Notice D'utilisation

Problem
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.

8.3 Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
There is no cold air circu-
lation in the appliance.
3. Remove the lamp cover (2).
4. Replace the lamp with one of the
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the
1
Climate
class
SN
N
ST
T
Solution
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
same power and specifically designed
for domestic appliances only.
lamp comes on.
2
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 27