Hitachi Koki NV65AH Mode D'emploi page 5

(2) It is recommended using the recommended oil (SHELL
TONNA). Other applicable oils are listed. Never mix
two or more types of different oils.
3. Load nails
(1) Press the magazine stopper and open the magazine
cover. (Fig. 1)
Magazine Cover
Nail Holder
(2) Adjust the position of the nail holder according to the
nail length.
The nail will not feed smoothly if the nail holder is
not correctly adjusted.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Move the nail holder up and down to align the top
of the nail holder with a mark on the holder shaft
in accordance with the length of the nails being
used.
3 Turn the nail holder 90 degrees clockwise until
you hear "click". (Fig. 2, 3)
Nail Holder
3
Top of the
Nail Holder
NOTE:
Before loading nails in the magazine, adjust the nail
holder. If the magazine cover is forcibly closed without
Magazine Stopper
Fig. 1
Holder Shaft
2
1
Fig. 2
Holder Shaft
38mm (1-1/2")
45 and 50mm
(1-3/4" and 2")
57,60 and 64mm
(2-1/4", 2-3/8"
and 2-1/2")
Nail Holder
Fig. 3
adjusting the nail holder correctly, the nail holder
may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine opening. (Fig. 4)
First Nail
Nail
(4) Close the magazine cover.
(5) Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open.
(Fig. 5)
Knob
Nail Guide
First Nail
(6) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole
First Nail
Nail guide
Pawl
English
Magazine Opening
Magazine
Fig. 4
Magazine Opening
Fig. 5
Guide Slot
3
2
1
4
Feeder
Guide Surface
2
Fig. 6
4