Sony VSP-BZ10 Manuel D'installation page 24

Placing the Player
Vertically
When placing the player in a vertical
position, always use the supplied vertical
stand and secure the player to the stand as
illustrated.
Attaching the stand
Insert the player into the stand until it clicks
into place.
Removing the stand
Hold down the stand, and lift out the player.
24
Placing the Player Vertically / Connecting the Player
Connecting the
Player
Before connection
Note
Two IP addresses are required when
performing network operations.
Under factory default settings, IP addresses 1
and 2 are set to be automatically assigned by
DHCP.
If you want to restore the default conditions
after changing the DHCP and IP address
settings, first disconnect the power cord,
then reconnect it while holding down the
INFO button to reset the player settings.
IP Address 1 and 2 can be set in Signage Web
Manager. For details, check the Operating
Instructions (PDF format) stored on the
CD-ROM (Software & Manuals for Digital
Signage Player) supplied with the player.
Write down IP Address 1 and 2 in "Setup
Memo" on the back cover of this manual.
For IP Address 1 and 2, set unique addresses
that do not overlap with those of other devices.
Conect the player to a display and a
computer as follows.