Fcc/Ce Warning - Extel O'CONTROL JLT-8035 Guide D'installation Et D'utilisation

Masquer les pouces Voir aussi pour O'CONTROL JLT-8035:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
• Clean using a soft cloth only, do not use solvents. The guarantee is void if parts have been dismantled. Clean
the outside with a soft dry cloth only. Before cleaning, disconnect or power off the appliance.
The shop receipt or invoice is the proof of the purchase date.
9. SAFETY INSTRUCTIONS
Damage caused by the failure to follow the instructions in this manual leads to the termination of the war-
ranty. We cannot be held liable for the resulting damage!
We cannot be held liable for any damage to property or injury to persons caused by incorrect handling or
the failure to follow the safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to maintain this state
of affairs and ensure the best use of the product, the user must follow the safety instructions and warnings
contained in this manual.
The person using this system is responsible for it and must check that the video surveillance complies with
the laws applicable in the country of use.
- You must only use this product at a voltage included between: 100-240 Volts and 50-60 Hertz. Never attempt
to use the product with another voltage.
- Make sure that all the system's electric connections are compliant with the usage instructions.
- In commercial establishments, make sure you follow accident prevention rules for electric installations.
- In schools, training infrastructures, workshops... the presence of qualifi ed staff is required to check the
operation of electronic devices.
- Follow the usage instructions for the other devices connected to the system. (VCR, TV, PC for example)
- Please contact an experienced person if you have doubts as to the operation or safety of the appliances.
- Never connect or disconnect electric appliances with wet hands.
- When installing this product, check that the power supply cables are not in danger of being damaged.
- Never replace damaged electric cables yourself! If they are damaged, remove them and call on an experi-
enced person.
warning Warns the user of the presence of important instructions about use and maintenance
(repair) in the documents accompanying the appliance.
- The power supply should be near the unit and must be easily accessible.

10. FCC/CE WARNING

Comment: This equipment has been tested and found compliant with the limits of a class B appliance, in com-
pliance with applicable European standards. These limits are designed to provide reasonable protection from
interferences in a residential installation. This equipment uses, and can transmit radio frequency energy and, if
not installed and used following instructions, can cause interference to radio communications.
However, there is no guarantee that the interferences will not occur in a specifi c installation. If this equipment
causes interferences to radio or TV reception, which can be determined by powering the equipment on and
off, the user is encouraged to attempt to rectify the interferences using at least one of the following methods:
• Redirect or move the receiver antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to a socket on a different circuit than the circuit the receiver is connected to
GB6
CFI EXTEL O'CONTROL - 10/2015 - V1

Publicité

Table des Matières

Dépannage

loading

Table des Matières