Charging The Batteries; Use; Technical Characteristics; Technical Specifi Cations - Extel O'CONTROL JLT-8035 Guide D'installation Et D'utilisation

• Select the icon
• Choose 'Add'
• Choose Cam 1 – press OK to validate
• Turn on the camera, press the on/off button 3 times quickly, the 'power' LED will fl ash for 2 secs. and then
will turn on completely when the pairing is complete.
c. Charging the batteries
WARNING
When connecting the monitor and camera for the fi rst time, the batteries must be recharged for 12 hours.
1. Connect the monitor / camera to their respective adapters (indications)
2. Plug the adapters into a power outlet and leave them plugged in for about 12 hours to charge the batteries.
3. Use without an adapter:
Monitor lithium battery autonomy: 2 hours
Camera lithium battery autonomy: 2 hours
• Battery charge status display
When the battery is about to run down, the
is not recharged, it switches off automatically when the voltage is too low until it is plugged back into a mains
power outlet.

5. USE

Signal level
cam1 Camera station
20°C
Temperature around the camera
Night mode (triggers the IR LED)
Alarm
Microphone
Battery status
Volume setting
Brightness setting
Play the camera tunes
Ok to validate the tune
Then raise/lower to adjust the sound level.
ZOOM
Alarm
Add/remove a camera (pairing)
• Add: Add a camera
• Del: Remove a camera
• View: select the camera to view
• Scan: Sweep using the connected cameras. Set time of about 10 secs.
Temperature unit C°/F°

6. TECHNICAL CHARACTERISTICS

a. Technical specifi cations
Frequency: 2400 MHz – 2480MHz
Range: 200 m in a free fi eld
Operating temperature: 0° - 60°
GB4
symbol is displayed on the monitor screen. If the monitor
CFI EXTEL O'CONTROL - 10/2015 - V1