Assembly Recommendations - dirna Bergstrom bycool blue line SCANIA NTG FLAT Instructions De Montage

FLAT
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
! Warning
When installing the evaporative unit in the ceiling, protect
the upper part of the cabin with a cloth or sheet to prevent
scratching. When installing Bycool Flat in the ceiling, bear
in mind that cabins are normally fitted with a hatch and
have a structure which can withstand the weight of the unit.
However, if this is not so and it is necessary to open up
the ceiling, or should the hatch material not be sufficiently
resistant (e.g. fibre, plastic, etc) the installer must decide,
under his sole responsibility, on the need to reinforce
the ceiling in order to prevent deformation, breakage,
incoming water, etc, and use the means necessary to this
end.
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10, 13, 14
Scissors
Flexo-meter
Documentation included
Mounting instructions
User's guide
Troubleshooting
Included parts
Fragile
Beware of cuts!
Electrical hazard
!
Piece 20 of the listing of provided pieces must be
replaced every 12 months.
!
Dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from mo-
difications and substitutions carried out without our
express and written authorisation.
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control
panel.
16
Tools
1001693734
220AA70003
220AA70004
1001693728
Symbology
! Warnings
®