Velleman CAMCOLD7 Notice D'emploi page 5

$!
7.
Remove the mounting plate (8) from the housing (7) by turning it clockwise and lifting it.
•
Fix the mounting plate (8) to the ceiling with 4 screws.
•
Attach the dome to the mounting plate (8). To do this, line up the pins on the mounting
•
plate (8) with the holes in the housing. Put the dome on the mounting plate (8) and
rotate counter clockwise to secure it.
Connect the video output (9 ) to a monitor/DVR/multiplexer/....
•
Connect the communication cable (9#) to the IR receiver ( , ; and <):
•
Yellow lead
Blue lead
Use the yellow and blue leads to make a connection to the IR receiver and/or an existing
•
tamper switch (not incl.), motion sensor (not incl.), alarm system (not incl.), etc.... .
Provide power to the power input (9)) of the dome.
•
Connect a 12VDC/1A power supply (e.g. PS1210 = not included) to the DC power input
•
(:) of the IR receiver.
' $!
8.
After applying power to the mini dome, the camera will move to its initial position and the
•
system will be in standby mode.
To allow the controller to detect all connected mini pans/tilt domes, press [0] followed by
•
[ENTER]. After successful detection, the receiver box will produce a short beep. When
detection fails, a long beep followed by 3 short beeps will be produced.
only the 9 lowest ID numbers can be controlled by the remote control.
Select the mini pan/tilt dome to be controlled by pressing the numeric button ([1]~ [9])
•
on the remote control, followed by [ENTER].
there is no direct relationship between the entered number and the ID of the mini
pan/tilt dome. The dome with the lowest ID will be assigned to button [1] and so on.
To move the camera position, use the up/down/left/right keys on the remote control.
•
Note that only the camera direction will change, not the speed.
The mini pan/tilt dome can store 16 preset points which can be recalled instantly.
•
To configure a preset point, go to the desired dome and move to the desired camera
•
position with the up/down/left/right keys on the remote control. Enter a preset number by
pressing the desired number on the remote control followed by the [SET PRESET] button.
Follow the same procedure for more preset points. Entering an existing preset number
will override the previous preset point with the new configuration.
To recall a preset point, go to the desired dome and simply press the preset number
•
followed by the [GO PRESET] button on the remote control.
The mini pan/tilt dome contains an auto pan function. Depending on the chosen option,
•
the camera will automatically scan 4, 8 or 16 preset points:
[1]
[2]
[3]
To start auto pan, select a number ([1]~[6]) and push the
•
control.
To stop auto pan mode, press
•
direction button.
as the remote control is universal, following buttons are not operational:
[AUTOFOCUS] [ZOOM IN] [ZOOM OUT] [FOCUS NEAR] [FOCUS FAR] [SPEED +]
[SPEED =]
When an alarm condition occurs (yellow lead), the buzzer inside the IR receiver will be
•
activated. To deactivate, press the =
will switch automatically to the camera that triggered the alarm.
00 (17/09/2008)
Alarm input
Ground
fast pan, 4 preset points
slow pan, 4 preset points
fast pan, 8 preset points
Green lead
Red lead
[4] slow pan, 8 preset points
[5] fast pan, 16 preset points
[6] slow pan, 16 preset points
again in the remote control, or simply press a
. key on the remote control. The controller
5
RS=485 D+
RS=485 D=
key on the remote