Before First Use; Adjusting The Water Softener; Water Hardness - Electrolux ESF 6610ROW Notice D'utilisation

28 www.electrolux.com
There is also an acoustic signal that oper-
ates when the programme is completed.
By default, this acoustic signal is off, but it
is possible to activate it.
How to activate the acoustic signal
for the end of programme
1. Press the on/off button to activate the
appliance.
2. Press and hold, at the same time,
Program and TimeSaver for a few
seconds.
3. Press and hold, at the same time, De-
lay and Option until the indicators
, and

6. BEFORE FIRST USE

1. Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.

6.1 Adjusting the water softener

German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
start to flash.

Water hardness

French
degrees
(°fH)
91 - 125
76 - 90
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
< 7
4. Press Delay,
• The indicators
• The indicator
• The display shows the current set-
ting.
5. Press Delay to change the setting.
6. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
5. Processing residues can stay in the
appliance. Start a programme to re-
move them. Do not use detergent and
do not load the baskets.
If you use the combi detergent
tablets, activate the Multitab op-
tion.
mmol/l Clarke
degrees
9.1 - 12.5 64 - 88
7.6 - 9.0 53 - 63
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
< 0.7 < 5
and
continues to flash.
Acoustic signal on
Acoustic signal off
Water softener
adjustment
Manual
1)
2
1)
2
1)
2
1)
2
1)
2
1)
2
1
1
1
2)
1
go off.
Elec-
tronic
10
9
8
7
6
1)
5
4
3
2
2)
1