RIDGID SeeSnake CS10 Guide De Démarrage Rapide page 4

SeeSnake CS10 Quick Start Guide
Operating Instructions
1. Tilt the CS10 back slightly and pull forward on the tilt stand until it locks in
place.
2. Raise the front cover by depressing the orange cover release buttons on each
side of the unit and lift up on the cover until it locks securely into place.
3. Insert at least one battery into the CS10 battery dock or plug the external
power cord into a standard outlet.
4. Connect the CS10 to a SeeSnake camera inspection system.
5. Press the Power Key
6. If desired, press and hold the Zero Key
7. Push the camera head through the line.
cordance with the SeeSnake Reel's operator's manual.
USB Port
Insert a thumb drive into the USB port to store images and video captured by the
CS10. The CS10 cannot capture video, Autolog video, or photos until a thumb drive
is inserted into the USB port. The USB LED will be ON steadily when ready for use.
Jobs
The CS10 automatically saves photos, videos, and Autolog videos to the latest Job
on the thumb drive. The CS10 will open a new Job if there is not already one on the
thumb drive. The CS10 will save media files to a new session on the thumb drive
when the thumb drive is ejected and when the CS10 shuts down.
Recording Autolog Video
Autolog video captures a highly compressed video of an inspection, but uses a
smaller file size than standard video. Press the Autolog Key
recording an Autolog video. The Autolog LED will be lit during Autolog recording.
Press the Microphone Mute Key
log video without audio.
Press the Photo Key
frame rate video clips while recording an Autolog video.
Recording Video
Press the Video Key
Main Keypad will be lit during video recording.
Video and Autolog video can be recorded simultaneously and independent of each oth-
er. Both video recording types can be started and stopped without affecting the other.
Taking Photos
Press the Photo Key
4 – English
to turn ON the CS10 and the camera.
to turn OFF the microphone and to record Auto-
or the Video Key
to start and stop recording a video. The Video LED on the
to take a photo.
to zero the counter.
Proceed with pipe inspection in ac-
to capture additional photos or higher
to start and stop