Chicco SCOOP Mode D'emploi page 17

base of the handle at the same time and then
turn it downwards (fi gure 8 B).
WARNING: Do not transport the carrycot with
the handle in the middle or rest position, but only
with the handle in carrying position.
WASHING
The hood, internal lining of the carrycot, and mat-
tress are removable and may be washed; it is ad-
vised to carefully follow the washing instructions
shown on the item's label.
9- Remove the hood of the carrycot following the
instructions in point 3; then release the two
press studs that fasten the metal arch to the
fabric, and only pull out the metal arch by
pulling it from one of the two ends (fi gure 9);
do not pull out the rear arch with the 4 tabs
for washing.
10- Remove the mattress padding through the
opening located on the back of the cover
(fi gure 10).
11- To remove the internal lining of the carrycot,
slip the plastic band located in the baby's
head zone, releasing the lateral press studs,
velcro, and the two tabs in the feet area (fi g-
ure 11).
The washing symbols and their signifi cance are as
follows:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
USING THE CARRYCOT AS A BABY CARRIAGE
This carrycot can be used as a baby carriage
mounted on Chicco strollers that have the "Click
Clak" system.
HOW TO ATTACH THE CARRYCOT TO THE
STROLLER
Prepare the stroller, equipped with the Clik Clak
system, to mount the carrycot as shown in the
instructions of the specifi c stroller.
NB: For strollers equipped with a backrest or
removable seat, it is advisable to unhook the
backrest or seat as shown in the specifi c stroller
instructions sheet.
12- Grip the carrying handle in the transport posi-
tion and place the carrycot on the arms. The
baby's feet end of the carrycot should be clos-
est to the stroller's handle (fi gure 12).
13- Align the pins on the two sides of the carrycot
with the openings located on the arms of the
stroller (fi gure 13 A), then carefully set down
the carrycot until you hear the lock click (fi g-
ure 13 B).
WARNING: Before using, make sure that the car-
rycot is properly locked on by pulling on it up-
wards.
REMOVING THE CARRYCOT
14- Bring the handle to its vertical position (trans-
port mode) until you hear a click which means
it is locked in place (fi gure 14).
15- Push the button located on the front part
of the baby carriage (fi gure 15 A), therefore,
keeping the button pressed; lift the carrycot
off of the structure (fi gure 15 B).
WARNING: The carrycot can be attached or re-
moved with the baby in it; the said operations
may be harder to perform due to the weight of
the baby. Pay careful attention when performing
the operations stated above.
WARNING: Incorrect attachment of the carrycot
to the frame (e.g. mounting backwards) could re-
sult in malfunction of the locking system, making
it impossible to remove: In this case, refer to the
stroller instructions or contact Artsana Customer
Service.
FÜR WEITERE INFORMATIONEN:
CHICCO Babyausstattung GmbH
Postfach 2086
63120 Dietzenbach
Sservice-tel.: 08000 24 42 26
www.chicco.com
17