Bench Alignment; Static Alignment; Dynamic Alignment - endolite Javelin JAV22L1 Instructions D'utilisation

6 Bench alignment

½
*
Approx.
1/3
Build
Line
½
2/3

Static Alignment

Set Up length
Note: Shin pylon should be vertical when used
with a 10mm heel height shoe. Lower heel
height shoes may require the use of a packing
piece below the heel.
Cut shin to approximate length, allowing
10-15mm for final trimming. Note trial length
will typically include 5mm to allow for axial
compression of heel and toe.
Build Line
This should fall 1/3 of the foot length from the
heel.

Dynamic alignment

Coronal Plane
Ensure that M-L thrust is minimal by adjusting
relative positions of socket and foot.
Sagittal Plane
Check for smooth transition from heel strike
to toe off. Ensure also that when standing the
heel and toe are evenly loaded and that both
are touching the floor.
Trans-femoral Alignment
Align trans-femoral devices according to fitting
instructions supplied with the knee, keeping
the build line relative to the pylon as shown.
*
Allow for users
own footwear
5 938306/3-1214