Setting The Clock - auna Stanford Mode D'emploi

Ein-/Ausschalten:
Modus Wählen:
Switch to standby. Press and hold CLOCK on the RC. Enter the digits for hours and minutes, using the
number buttons on the RC. Confirm by pressing CLOCK.
In FM or DAB mode, press DISPLAY on the RC to show the current time.
While listening, press SLEEP repeatedly to activate and set the sleep time. With each time pressing SLEEP,
the time is diminished a bit: 120 min - 90 min - 60 min - 30 min - 15 min - OFF (inactive).
After expiration of the set time, the device shuts down to standby automatically.
To deactivate the sleep timer, press sleep repeatedly, until the display shows "OFF".
Set the timer to use the device as an alarm clock. The time has to be set properly beforehand. Switch to
standby and press TIMER, to activate the function.
Then, hold TIMER, to enter the timer settings routine. Select the source first (FM, DAM, CD, etc.), using the
arrow buttons. Press TIMER to confirm and continue. Next, enter the desired alarm time with the numerical
buttons and press TIMER again. Now, adjust the alarm volume with the arrow buttons and, again, press
TIMER. At last, enter the time you wish the alarm to stop (arrow buttons, confirm with TIMER button).
Please note: If BUZZER is selected as alarm source, the "off time" option is not available. The settings menu
will be quit upon 10 seconds without changes.
22
Operation
Press and hold to switch on/off..
Please note: When no audio signal is processed and no (button) operation is registered, the
device automatically shuts down after 19 minutes to save energy (exception: FM mode).
Repeatedly press
USB - BT - AUDIO - AUX - CD - DAB - FM. Alternatively, use the corresponding
buttons on the remote control.

Setting the Clock

Sleep Timer
Basics
on the device top, to select the desired mode
Timer
www.auna.de