FALMEC blade isola Mode D'emploi page 24

Speed 2 button
With LED on (speed 2 already running):
Nothing will happen when this key is pressed. To switch the hood off firstly select speed 1, then press the "speed 1 button" again.
With the LED off and a speed on:
Press the key (long or not) to set the hood on speed 2. When speed 2 is running the relative LED will light up.
With the LED off and NO speed on:
Nothing will happen when this key is pressed.
Speed 3 button
With LED on (speed 3 already running):
Nothing will happen when this key is pressed. To switch the hood off firstly select speed 1, then press the "speed 1 button" again.
With the LED off and a speed on:
Press the key (long or not) to set the hood on speed 3. When speed 3 is running the relative LED will light up.
With the LED off and NO speed on:
Nothing will happen when this key is pressed.
Speed 4 button
With LED on (speed 4 already running):
Nothing will happen when this key is pressed. To switch the hood off firstly select speed 1, then press the "speed 1 button" again.
With the LED off and a speed on:
Press the key (long or not) to set the hood on speed 4. When speed 4 is running the relative LED will start flashing; the 4th, or inten-
sive, speed is timed and after approximately 7 minutes the motor will automatically switch to 3rd speed.
With the LED off and NO speed on:
Nothing will happen when this key is pressed.
Light Button
Light:
By briefly pressing the key (the back-lit button), you turn the light on and off.
LIGHTING
The hood has fluorescent lamp lighting.
If the lamp ever needs to be replaced:
R
Phase page 9
remove the covering element (N) (Fig.
take out the blown fluorescent tube (M) (Fig.
put in a new fluorescent lamp by performing, in reverse order, the operations described in Fig.
The new fluorescent lamp must be identical to the old one!
put the covering element back in (N) performing, in reverse order, the operations described in Fig.
connect the appliance back up to the electrical power mains.
disconnect the appliance from the electrical mains power supply by unplugging it or turning off the main switch;
open the external suction panel (see instructions
1 2
and );
3 4
and );
O
on page 9);
3
and
24
4
;
1 2
and ;