De Fastheat - Calf Milk Warmer With Convection Heating; General Notes; Safety Notes - Kerbl FastHeat Mode D'emploi

DE FastHeat – Calf Milk Warmer with Convection Heating
EN

1. General Notes

These operating and safety instructions are intended for the user. Please read the instructions carefully and adhere to the regulati-
ons and notes before operating the device.
2. Purpose / Correct Usage
The calf milk warmer is designed for the warming of milk and feed that has been prepared with water. The calf milk warmer may
not be used for other purposes, specifi cally the prevention of the freezing of water in feed troughs and the warming of aggressive
liquids.

3. Safety Notes

3.1. Use:
The warranty and liability of the manufacturer do not apply in the event of incorrect use of or interference with the device. The
voltage information on the type plate must conform to the voltage of the power supply.
3.2. Please check all components before each use. Damaged parts may only be repaired by specialists or by the manufacturer. If
repairs are carried out incorrectly or the user fails to carry out repairs then this can cause operator accidents. Do not operate the
device if it or one of its components is defective. Always use original spare parts for any repairs.
3.3. Safety
Always pull the mains plug out fi rst before cleaning, adjusting or maintaining the device.
3.4. Protect the connection lines. Do not use the connection line to pull the power plug or to carry the device. Ensure that the
connection lines do not come into contact with heat, oil or sharp edges. Damaged connection lines can cause fi res, short circuits
and electrical shocks. If the connection line on this device is damaged then it must be replaced with a specifi c connection line,
available from the manufacturer or their customer service representative.
3.5. Regular maintenance.
Always keep the device in a dry, safe place, out of the reach of children. Please adhere to any maintenance requirements. Check
your device at regular intervals. Only use original accessories and spare parts.
3.6. National and international regulations
Please adhere to national and international safety, health and work safety regulations.
4. Operating Instructions
4.1. Submerge the heating element on the calf milk warmer in the liquid that you wish to warm. Please note the
maximum submersion depth, shown by the groove on the upper end of the submersion pipe. Do not exceed this level. The
heating ring must be fully submerged in the liquid and the handle must never come into contact with the liquid. The contai-
ner must be made of heat-resistant material. Never use plastic containers!
Do not exceed maximum submersion depth! (level marked „max.", see diagram on page 22)
Do not submerge below minimum submersion depth! (level marked „min.", see diagram on page 22)
4.2. Plug the mains plug into a socket that was installed by a recognised specialist and that is fi tted with a fault circuit interrupter
(FI) with an operating current of 30 mA. From now on the liquid may not be touched!
6