Monacor AKB-90WIFI Notice D'installation Et D'utilisation page 10

5 Operation
1) At the player (smartphone, tablet PC, com-
puter, etc.), switch on the WLAN function.
2) Establish the connection to the amplifier.
On the player, the amplifier will be indi-
cated by "WiFi-HiFi_" and four digits. Each
amplifier has a digit sequence of its own so
that it is possible to select individual ampli-
fiers when multiple amplifiers are used.
3) Start the DLNA player.
5.1 Configuring the AKB-90WIFI
The amplifier can be configured by means of
the integrated web server. Enter the IP
address of the AKB-90WIFI in an Internet
browser: 10.10.10.254
It is, for example, possible to change the
shown name "WiFi-HiFi_xxxx" and the menu
language of the web server or to install the
latest firmware.
To reset the amplifier to its factory settings,
keep the pushbutton RST (4) pressed for at
least 5 seconds.
5.2 Connection to a WLAN router
With the WPS function (WiFi Protected
Setup), the AKB-90WIFI can be easily con-
nected to a WLAN router provided that the
router supports WPS: Briefly press the push-
button RST (4). The AKB-90WIFI will auto-
matically transfer the data required to a
WLAN router in the reception range.
As an alternative, use the web user inter-
face of the AKB-90WIFI to connect it manu-
ally to a router, e. g. when WPS is not sup-
ported by the router.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
10
6 Specifications
Amplifier
RMS output power: . . . 2 × 45 W at 4 Ω
Amplifier class: . . . . . . . class D
Speaker impedance: . . 4 Ω min.
Frequency range: . . . . . 20 – 20 000 Hz
S / N ratio: . . . . . . . . . . . > 98 dB
Data transmission
WLAN standard: . . . . . . 802.11 B / G / N,
Range: . . . . . . . . . . . . . approx. 110 m with-
Supported
audio formats: . . . . . . . MP3, WMA, AAC,
Network protocols: . . . . TCP/ IP, UDP,
Audio protocols: . . . . . . DLNA, AirPlay,
SSID: . . . . . . . . . . . . . . WiFi-HiFi_xxxx
IP address: . . . . . . . . . . 10.10.10.254
General
Power supply: . . . . . . . 19 V ,
Power consumption
in standby mode: . . . . . 200 mA
Ambient temperature: . 0 – 40 °C
Dimensions: . . . . . . . . . 170 × 34 × 100 mm
Weight: . . . . . . . . . . . . . 750 g
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
2.4 GHz
out obstacles in the
transmission path
AAC+, ALAC,
FLAC, APE, WAV
HTTP, UPNP
QPlay
via power supply
unit provided and
connected to
230 V~ / 50 Hz