Mib : Bridge-Mib::dot1Dbridge - Etic Telecom XSLAN Guide De Configuration

Numeric OIDs
Replace "ifindex" with the SHDSL interface index in the table below.
hdsl2ShdslEndpointCurrAtn
hdsl2ShdslEndpointCurrSnrMgn
hdsl2ShdslEndpointCurrStatus
hdsl2ShdslEndpointES
hdsl2ShdslEndpointSES
hdsl2ShdslEndpointCRCanomalies
hdsl2ShdslEndpointLOSWS
hdsl2ShdslEndpointUAS
3.3.2 Table HDSL2-SHDSL-LINE-MIB::SpanStatusTable
OID hdsl2ShdslStatusActualLineRate (.1.3.6.1.2.1.10.48.1.2.1.3.ifindex) : data rate of the SHDSL line.
•
It is recommended to monitor this OID, if the chosen profile for the line is not a fixed datarate profile.
The other fields are not supported and are set to 0.
3.3.3 Table HDSL2-SHDSL-LINE-MIB::SpanConfProfileTable
This table gives the list of the profiles defined for the SHDSL links configuration.
These informations are the same as the ones in the web page « SHDSL ports »
3.3.4 Table HDSL2-SHDSL-LINE-MIB::SpanConfTable
This table gives the SHDSL profile associated with each SHDSL port.
3.4

MIB : BRIDGE-MIB::dot1dBridge

Information about the Ethernet bridge are gathered under this OID. This MIB is published by the IETF under
RFC4188.
3.4.1 OID BRIDGE-MIB::dot1dBase
The following information is displayed :
• OID BRIDGE-MIB::dot1dBaseBridgeAddress : Bridge MAC address
OID BRIDGE-MIB::dot1dBaseNumPorts : Number of ports in the bridge
•
OID BRIDGE-MIB::dot1dBaseType : Type of bridge (Tranparent-only)
•
DOC_DEV_XS_Guide de configuration_C
.1.3.6.1.2.1.10.48.1.5.1.1.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.2.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.3.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.4.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.5.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.6.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.7.ifindex.0.1.1
.1.3.6.1.2.1.10.48.1.5.1.8.ifindex.0.1.1
ANNEXE 1
page 79