Getting Started; Replacing The Batteries - Hama BlackLine Plus Mode D'emploi

4. Getting Started

Note
Please remember, during commissioning, to always
insert the batteries into the outdoor sensor rst and
then into the base station.
4.1 Insert batteries / connect power supply
Outdoor sensor
• Remove the screen protector from the display.
• Open the battery compartment and remove the contact
breaker.
• Then close the battery compartment cover.
Base station
Warning
• Connect the product only to a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• When using a multi-socket power strip, make sure
that the sum power draw of all the connected devices
does not exceed its maximum throughput rating.
• If you will not be using the product for a long period
of time, disconnect it from mains power.
• Remove the screen protector from the display.
• Connect the power supply unit to the power supply unit
connection socket (G) on the back of the base station.
• Connect the weather station's power supply unit to a
correctly installed mains socket.
• Alternatively, open the battery compartment (H), insert
three AA batteries with the correct polarity and close
the battery compartment cover.
4
Note
If the batteries are inserted correctly and you connect
the power supply unit to the station, the base station
will automatically switch to the external power supply.

4.2 Replacing the batteries

Note – Replacing the batteries
• Be aware that, after every battery change on the
outdoor sensor or base station, the stations will need
to be resynchronised.
• To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
Outdoor sensor
• If the symbol (18) appears, replace the 2 AA
batteries in the outdoor sensor with 2 new batteries.
• Open the battery compartment, remove and properly
dispose of the dead batteries and insert 2 new AA
batteries with the correct polarity. Then close the battery
compartment cover.
Base station
• When the symbol (25) appears, replace the three AA
batteries for the base station with three new ones.
• Open the battery compartment (H), remove and properly
dispose of the depleted batteries and insert three new AA
batteries with the correct polarity. Then close the battery
compartment cover.
5. Installation
Note – Installation
• We recommend initially positioning the base station
and outdoor sensor at the preferred setup locations
without assembling them and carrying out all the
settings - as described in 6. Operation - rst.
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.