Getting Started; Measuring Station; Base Station; Replacing The Batteries - Hama EWS-Trio Mode D'emploi

• Do not open the device or continue to operate it if it
becomes damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Do not mix old and new batteries or batteries of a
different type or make.
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Do not charge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.

4. Getting started

Note
Before use, make sure that you insert the batteries in the
measuring station first and then in the base station.

4.1 Measuring station

• Open the battery compartment (21) and insert two
AA batteries with the correct polarity into the battery
compartment.
• Use the slide switch (20) to select the channel that the
respective measuring station is to use for transmission.
Each of the three measuring stations must use a different
channel!
• Close the battery compartment.

4.2 Base station

• Open the battery compartment (15) and insert three
AAA batteries with the correct polarity into the battery
compartment.
• Then close the battery compartment cover.

4.3 Replacing the batteries

Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring
or base station.
• To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
Measuring station
• If the symbol is displayed on the basis station in the
measurement values area of one of the three measuring
stations (5/6/7), replace the two AA batteries of the
affected measuring station with two new ones.
• Open the battery compartment (21), remove and properly
dispose of the depleted batteries, and insert two new AAA
batteries with the correct polarity. Then close the battery
compartment cover.
Base station
• If the symbol is displayed on the base station in the
indoor values area (2), replace the three AAA batteries in
the base station with three new ones.
• Open the battery compartment (15), remove and properly
dispose of the dead batteries and insert three new AAA
batteries with the correct polarity. Then close the battery
compartment cover.
3