JB Systems CD 100 Mode D'emploi page 4

1. STOP - Stops the CD.
2. OPEN/CLOSE
3. LCD DISPLAY - Shows time (minutes, seconds, frame) and
pitch information.
4. SGL/CTN - Switches between Single or Continuous play
modes.
5. CUE INDICATOR
6. CUE - Used to recall and preview the cue point.
7. PLAY/PAUSE INDICATOR
8. PLAY/PAUSE - Plays or pauses the CD.
9. LOOP IN INDICATOR
10. LOOP IN - This allows you to set the cue point without stop-
ping the play back. This button sets the beginning of a loop.
11. LOOP OUT - Used to set the ending when looping music.
The player will start to loop continuously until you press this
button again to exit.
12/13. - Press the button to forward and backward frame.
When you press the start button in pause mode a new cue
point is set automatically. Scans forward or back through
the current track. This unit features 3 scan speeds. Hold the
or
14. B. SKIP
the current track or to select a previous track for playing.
15. F. SKIP
16. LOOP OUT INDICATOR
17. TIME - LCD display shows the remaining or elapsed time or
the total remaining time.
18. PITCH BEND - When this button is pressed the pitch is
temporarily changed. Note: maximum pitch on this unit is
16%. If the pitch fader is already set to 16%, this function
will not work.
19. PITCH FADER - Used to speed up or slow down the current
track.
CD 100
– Press it to open and close the disc holder.
button for a few seconds to change the scan speed.
- Use this button to go back to the beginning of
- Use this button to go to the next CD track.
4