Atag VA61111KT Notice D'utilisation page 19

Using the detergent
A B D
30
20
Using the combi detergent
tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser. The rinse aid indica-
tor always comes on if the rinse aid dis-
penser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi
detergent tablets, before you start
to use separately detergent, rinse
aid and dishwasher salt, do these
steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a
programme
Reset function
For some settings it is necessary that the
appliance is in user mode.
The appliance is in user mode when all the
programme indicators are on.
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
To set the appliance in user mode, do the
Reset function
1. Press and hold the programme button
until all the programme indicators come
on.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Press the programme button again and
again until only the indicator of the pro-
gramme you want to set is on.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button to delay the start
of the programme of 3 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
Do the Reset function.
When you cancel the delay start, you
have to set the programme again.
19