External Cleaning; Troubleshooting - Atag VA61111KT Notice D'utilisation

22

External cleaning

Clean the appliance with a moist soft cloth.

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
Alarm code
• The end indicator flashes 1 time intermittently.
• Acoustic signal sounds 1 time intermittently.
• The end indicator flashes 2 times intermittent-
ly.
• Acoustic signal sounds 2 times intermittently.
• The end indicator flashes 3 times intermittent-
ly.
• Acoustic signal sounds 3 times intermittently.
Warning! Deactivate the appliance
before you do the checks.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
With some problems, the end indicator
flashes intermittently to show an alarm
code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Problem