Starting and setting the appliance
Operation of the electronic system
The control panel on your appliance's door
contains:
- 1) An LCD screen display
- 2) ">" button
Starting the appliance:
Holding down this button starts the appliance.
Function selection
The functions are selected by holding down
the ">" button until the desired function starts
to flash. The sequence for selecting the
functions is always the same:
1.
Start
2.
Set refrigerator temperature
3.
Quick chill
4.
Set freezer temperature
5.
Quick freezer
6.
Holiday
- 3) "-" button: This serves to:
- Reduce the temperature when in "Set
refrigerator temperature" or "Set freezer
temperature" mode.
- Deactivate a function.
1
2
3
4
- 4) "+" button: This serves to:
- Increase the temperature when in "Set
refrigerator temperature" or "Set freezer
temperature" mode.
- Activate a function once selected.
Every time you confirm or deacti-
vate a function a beep sounds.
Setting the temperatures
When you first start your appliance, set the
temperatures to a moderate setting (5°C in
the refrigerator section and -18°C in the
freezer section).
4 hours after starting your appliance or after
any change to the temperature set in the
refrigerator section, check the temperature
"OK" indicator on the screen (see the symbols
table).
- If the indicator does not appear, lower the
temperature a little and check the "OK" indica-
tor again after 4 hours. Repeat the operation
as many times as required.
- If the "OK" indicator appears on your screen,
your refrigerator's temperature is set correctly.
43
EN