Technical Data - 3M PELTOR SportTac MT16H210F Mode D'emploi

FP3584_reve_.indd 2
• The fitting of hygiene covers to the cushions may affect the acoustic performance of the
ear-muffs.
• This ear-muff is provided with level-dependent attenuation. The wearer should check
correct operation before use. If distortion or failure is detected, the wearer should refer to
the manufacturer´s advice for maintenance and replacement of the battery.
• This ear-muff is provided with electrical audio input. The wearer should check correct
operation before use. If distortion or failure is detected, the wearer should refer to the
manufacturer's advice.
• Follow the advice in this manual on maintaining and replacing batteries.
• Performance may deteriorate with battery usage. The typical period of continuous use that
can be expected from the ear-muff battery is 600 hours.
• The output of the level-dependent circuit of this hearing protector may exceed the external
sound level.
• The output of the electrical audio circuit of this hearing protector may exceed the daily limit
sound level.
5. MAINTENANCE
5:1 Replacing the ear cushions
(C:1) Slide your fingers under the edge of the ear cushion and pull straight out.
(C:2) Insert the new foam and ear cushion.
(C:3) Press until it snaps into place.
5:2 Cleaning
Remove the ear cushions and attenuation cushions (Fig. C) if you have been wearing the
product for a long time or if moisture has gathered inside the cups. Clean and disinfect the
cups, headband and ear cushions regularly with soap and warm water. Make sure the soap
is known not to be harmful to the wearer. Allow the product to dry before you use it again.
Do not immerse the product in water!
5:3 Use and Storage
Remove the batteries when storing the product. Do not store the hearing protector at
temperatures above +55°C, (for example on a dashboard, a parcel shelf or a window sill),
or at temperatures below –20°C. Do not use the hearing protector at temperatures above
+55°C, or below –20°C.
5:4 WEEE (Waste Electrical and Electronic Equipment) Symbol
Below requirement applies in the European Union.
Do NOT dispose your product as unsorted municipal waste!
The crossed-out wheeled-bin symbol indicates that all EEE (Electrical and
Electronic Equipment), batteries and accumulators must be disposed of according
to local law by the use of available return and collection systems.

6. TECHNICAL DATA

6:1 Standards and Approvals
3M Svenska AB hereby declares that this 3M™ PELTOR™ SportTac Headset is in
compliance with the essential requirements and other provisions set out in the appropriate
directives. Thereby it fulfils the requirements for CE marking. A copy of the declaration of
conformity and additional information required in the directives can be obtained by contacting
3M in the country of purchase. For contact information, see first pages of this user instruction.
The product has been tested and approved in accordance with EN 352-1:2002 / EN352-
4:2001 / A1:2005, EN 352-6:2002.
This product contains electrical and electronic components and must not be disposed of
using standard refuse collection. Please consult local directives for disposal of electrical and
electronic equipment.
Notified Body Statement of Opinion offered by:
FIOH, Finnish Institute of Occupational Health, Topeliuksenkatu 41 b, FI-00250, Helsinki,
Finland. Notified body #0403.
6:2 Explanation of the attenuation data (Table D)
1. Frequency (Hz)
2. Mean attenuation (dB)
3. Standard deviation (dB)
4. Assumed Protection Value, APV
5. Weight (g)
2
GB
2017-04-04 09:38:01