Restoring Nominal Values; Operation; Maintenance / Cleaning; Disposal - Vortice LINEO 100 V0 ES Notice D'emploi Et D'entretien

ENGLISH
the motor automatically runs at
V1temp
- cut off the power supply
- set Int.4=OFF to lock the V1 and
V2 values

Restoring nominal values

If necessary, the nominal factory-set values for V1
and V2 can be restored using the following
procedure:
- cut off the power supply
- set the dip-switch SW2 indicated
in the figure:
Int.3=ON
- restore the power supply:
V1 and V2 are automatically restored to the nominal
factory-set values corresponding to the selected
model, as described above. The restoring of
nominal values is indicated by two quick flashes of
an LED on the card.
The motor is
automatically
- cut off the power supply
- reset the dip-switch
indicated in the figure:
Int.3=OFF

Operation

Depending on the mode selected during installation:
- two-speed mode:
continuously; two speeds V1 and V2 can be
selected using an external switch
- adjustable speed mode: the appliance can operate
at a speed which is adjusted between 300 Rpm and
Vmax (via an external potentiometer). The VORTICE
ON/OFF control box + potentiometer (code 12826,
on request) can also be used.

Maintenance / Cleaning

Fig. 27, 28, 29.
ON
OFF
1 2 3 4
ON
OFF
1 2 3 4
deactivated
ON
OFF
SW2 1 2 3 4
the appliance operates

DISPOSAL

IN CERTAIN EUROPEAN UNION COUNTRIES THIS
PRODUCT DOES NOT
REQUIREMENTS OF THE NATIONAL LAWS
IMPLEMENTING THE WEEE DIRECTIVE, AND IN
THESE COUNTRIES THE PRODUCT IS NOT
SUBJECT TO SEPARATE DISPOSAL OPERATIONS
AT THE END OF ITS WORKING LIFE.
Important
This product conforms to EU Directive EU
2012/19/EC.
This appliance bears the symbol of
the barred waste bin. This indicates
that, at the end of its useful life, it
must not be disposed of as domestic
waste, but must be taken to a
collection centre for waste electrical
and electronic equipment, or returned
to a retailer on purchase of a
replacement.
It is the user's responsibility to dispose of this
appliance through the appropriate channels at the
end of its useful life. Failure to do so may incur the
penalties established by laws governing waste
disposal.
Proper differential collection, and the subsequent
recycling, processing
compatible disposal of waste equipment avoids
unnecessary damage to the environment and
possible related health risks, and also promotes
recycling of the materials used in the appliance.
For further information on waste collection and
disposal, contact your local waste disposal service,
or the shop from which you purchased the appliance.
Manufacturers and importers fulfil their responsibilities
for recycling, processing and environmentally
compatible disposal either directly or by participating
in collective systems.
FALL WITHIN THE
and environmentally
13