Télécharger Imprimer la page

Güde Blueflame 4200 T Traduction Du Mode D'emploi D'origine page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
damaged? In case of light damage, ask yourself
seriously if the tool is still safe to use and functioning
safely.
Prevent electric current injuries. Prevent any bodily
contact with an earthed object, e.g. water pipes,
radiators, cooking stoves and refrigerators.
Warning! Use of accessories and extensions not
recommended explicitly in these instructions may put
persons and objects at risk.
Make sure the plug is out of a socket before
performing maintenance or adjustment.
Correct use of the device:
Always follow and keep all instructions from this
manual when operating the device. Prevent use by
children or persons who were not acquainted with its
function.
Do not use the device when a defect or
malfunction has been detected.
If unusual sounds or strong vibrations occur during
operation which seem to suggest a malfunction, the
device must be immediately switched off and the
cause established by the nearest servicing shop.
Use only original spare parts.
In case of use of spare parts by other manufacturers,
the warranty becomes void and malfunctions in the
appliance may occur. Original spare parts can be
purchased from our business partners.
Do not make any alterations to the device.
Do not make any changes or alterations to the
device. All repairs must be performed by an
authorized servicing shop. Unauthorized change can
limit the output of the device but it can also cause
serious accidents if performed by persons without the
necessary technical knowledge.
It is absolutely necessary to know the regulations and
directives for accident prevention valid in the place of
operation, as well as the other general safety rules.
This tool complies with all appropriate safety
regulations. Repairs can be performed only by
qualified electricians in authorized service shops,
using only the original spare parts. Non-compliance
may cause a danger of accidents.
Device-specific safety instructions
The heating device can be used only in well-
ventilated spaces! (min. 40m³)
The device must not be operated in high-rising living
buildings, cellars, underground spaces, bathrooms
and bedrooms, vehicles like RVs, living trailers, boats
or spaces where another cylinder with liquid gas is
already placed.
This device can be used only standing on the floor.
This device can be used only in vertical position.
The heating device must be installed with regard to
fire prevention.
The heating device must not be covered with textiles
or other objects.
Install the heating device in such a way as to leave
enough space in relation to walls, furniture, textiles
and other possible sources of fire.
Always position the heating device so it points
towards the centre of the room.
Do not move the device when in operation.
The heating device cannot be used in apartments or
similar units if the space in the place of installation is
smaller than 40 m³ and it is not ventilated adequately.
An air-intake and exhaust must be provided through
openings, with a diameter of 2500 mm
of heat load, but they must be divided evenly together
for the upper and lower hole, with the total diameter
of minimum of 5000 mm
The device must not be operated in high-rising living
buildings, cellars, underground spaces, bathrooms
and bedrooms, vehicles like RVs, living trailers, boats
2
per kWh (Hs)
2
.
or spaces where another liquid gas cylinder is already
placed.
The heating device can be used at an enclosed
workplace only if all the appropriate regulations
regarding health and safety are met. (Organization of
workplace)
The minimum distance from other heat sources must
be at least 1 meter.
When installing the device, the minimum side
distance of 200 mm and front distance to other
objects of at least 1500 mm must always be
observed.
Do not cover the device when in operation. It could
cause overheating and a risk of fire.
The device must always be connected to an
operational earthing (grounding)(only item no.
85023).
Do not use the device near a bath tub, shower, wash
basin or swimming pool.
Do not put the electric cable on a hot surface or
equipment.
The hot air output grids must not be blocked.
The electric cable must not be replaced by the user.
The device cannot be installed directly to a firm
socket.
The air stream from the device must never point to
furniture, curtains or flammable materials.
In any case, the appliance must not be used as a
heat source in living rooms.
Never use the appliance unattended as it could
become a source of danger.
In any case, do not use the appliance to dry textiles.
Behaviour in case of emergency
Provide necessary first aid treatment corresponding to the
injury nature and seek qualified medical help as soon as
possible.
Protect the injured person from other injuries and calm
him/her down.
First aid kit must always be available in the place of
your work in case of accident in accordance with DIN
13164. Material taken out of the first aid kit needs to be
supplemented right away.
If help is needed,
please provide the following details:
1.
Place of accident
2.
Accident nature
3.
Number of injured persons
4.
Injury type
The designed purpose of use of the device
Gas fire for bottled gas heating in well ventilated
rooms (with minimum capacity of 40m³)
Any other use is in conflict with the designed
purpose!
Technical data
Maximum output
Consumption:
Nominal connection pressure:
Gas:
Weight:
Disposal
4200 W
300 g/h
50 mbar
Propan/Butan
10,5 kg

Publicité

loading

Ce manuel est également adapté pour:

85121