Ryobi OBL18JB Traduction Des Instructions Originales page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Use power tools only with specifically
designated battery packs. Use of any other
battery packs may create a risk of injury
and fire.
When battery pack is not in use, keep it away
from other metal objects, like paper clips,
coins, keys, nails, screws, or other small
metal objects that can make a connection
from one terminal to another. Shorting the
battery pack terminals together may cause
burns or a fire.
Under abusive conditions, liquid may
be ejected from the battery pack; avoid
contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid
ejected from the battery pack may cause
irritation or burns.
Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries
may
behaviour resulting in fire, explosion, or
risk of injury.
Do not expose a battery pack or tool to fire
or excessive temperatures. Exposure to
fire or excessive temperature above 130°C
may cause explosion.
Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specified in the
instructions. Charging improperly or at
temperatures outside the specified range
may damage the battery and increase the
risk of fire.
OPERATION
Operate the product only at reasonable
hours – not early in the morning or late at
night when people might be disturbed.
Never operate the product in an explosive
atmosphere.
Avoid using the product in bad weather
conditions especially when there is a risk
of lightning.
Keep bystanders, children and pets 15 m
away from the area of operation. Stop the
product if anyone enters the area.
Do not operate in poor lighting. The
operator requires a clear view of the work
area to identify potential hazards.
Operating similar tools nearby increases
both the risk of hearing injury and the
2
exhibit
unpredictable
potential for other persons to enter your
working area.
Always be sure of your footing on slopes.
Walk, never run.
Keep proper footing and balance. Do not
overreach. Overreaching can result in loss
of balance.
Never use the product with defective
guards or shields, or without safety devices
in place.
Do not modify the product in any way or
use parts and accessories that are not
recommended by the manufacturer.
WARNING
If the product is dropped, suffers heavy
impact, or begins to vibrate abnormally,
immediately stop the product and inspect
for damage or identify the cause of the
vibration. Any damage should be properly
repaired or replaced by an authorised
service centre.
To reduce the risk of injury associated
with contacting rotating parts, always stop
the product and remove the battery pack.
Make sure all moving parts have come to a
complete stop before:
leaving the product unattended
clearing blockages
checking, cleaning, or working on the
product
inspecting the product after striking a
foreign object
Immediately switch off and remove the
battery pack in the event of accident or
breakdown. Do not operate the product
again until it has been fully checked by an
authorised service centre.
BLOWER SAFETY WARNINGS
Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
Slightly
dampen
conditions.
Do not use the product near open windows.
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
surfaces
in
dusty

Publicité

Table des Matières
loading

Table des Matières