Maintenance; Tensioning The Belt - Scheppach Molda 5.0f Mode D'emploi

Documentation

Maintenance

Only perform maintenance, repair and cleaning work
when the motor is switched off.
Disconnect the mains plug!

All protection and safety devices must be
immediately reinstalled once the repair and
maintenance work is completed.

The machine tables should be kept free of
resin. Contact your Scheppach dealer for Pharmol
concentrated resin remover, article no. 6100 9700.

Occasionally clean and oil the regulating spindle
of the height adjustment system, its bearings and
drive shaft.

Tensioning the belt

Figure Z
Open the front-side machine cover.
-
Undo the belt-tensioning device.
-
- Remove the belt from the motor belt disc.
Remove the upper safety disc from the joint bolt
-
and remove the bolt.
Turn the tensioning lever (2) one or two turns
-
outwards.
Refit in the reverse sequence.
-
Page 56
Figure Z
1902103850