Electrical Connection - Scheppach Molda 5.0f Mode D'emploi

Documentation
Figure D
Mounting the complete curved moulding fence to
the machine table:
Supplementary set for curved moulding fence
(optional)
•
First affix the adjustment device for the curved
moulding fence to the guard.
•
Then affix this unit to the table plate using three
hexagonal screws and discs.
Curved fence plates
 The R 90 curved fence plate is fitted.
 The R 60 curved fence plate may have to be fitted
instead of the R 90 as required.

Electrical connection

When operating for the first time, the motor rotation direction must be checked.
Figure E
 Connect the machine to the mains supply using the CEE plug. The supply cable must be fused with
16A.
 The standard rotation direction is left (counter clockwise). The rotation direction selection switch
should be set to "forward". If not, the polarity should be switched using a screwdriver. See Figure E. The
rotation direction needs to be rechecked whenever the mains connection and machine location is
changed.
Page 40 1902103850