Operation - Scheppach Molda 5.0f Mode D'emploi

Operation


All protection and safety devices must be installed.

Only perform retooling, measuring and cleaning work when the motor is turned off. Wait until the rotating
tool comes to a halt before disconnecting the mains plug.
Moulding tool and insert ring
Figure G
Note the application of the various moulding tools.
Insert the corresponding insert ring (Ø115mm or
Insert ring Ø65mm: 7231 0739.
The Insert ring must be used when working
withmoulding tool greater than 110 mm.
Observe the rotation direction of the moulding tool!
Place the moulding tool and the spindle bushings on
the moulding spindle and secure them using the
safety disc and M 18x1.5 hexagonal nut. Firmly
tighten the spindle nut. (SW 41 single-head wrench)
Caution! Always insert the moulding tool in the lower
position.
Moulding fence
Figure H
Undo the two handles (1a) and align the fence guard
parallel to the front edge of the table.
(2) Fine adjustment of the moulding depth
Tighten the handles (1a), ensuring that the parallel
alignment of the moulding fence to the workpiece is
not altered.
Undo both handles (2a) and perform the fine
adjustment on handle (2). One scale mark on the
handle corresponds to 0.1mm.
Retighten the handles (2a) to their working position.
(3) Setting the fence profile
Undo the two handles (3) and set the two fence
profiles in accordance with the tool.
Align the fence profiles as closely to the moulding
tool as possible and tighten the handles.
A positioning pin in each of the fence profiles
prevents unintended removal of the fence profiles.
Unscrew the handles to replace the fence profiles.
FigureG
Figure H
1a
3 2a
2
Page 45