Scheppach Molda 5.0f Mode D'emploi page 51

Caution!
Switch off the motor and disconnect the mains
plug.
Replace the moulding tool!
Firmly tighten the spindle nut with the two SW 41
single-head wrenches.
When changing the tool, only touch the
-
moulding tool with gloves – danger of injury!
- Set the moulding tool and safety devices (see
"Correct set-up" chapter)
Reversing switch – selecting the rotation
-
direction
- Switch the motor back on.
Different applications for the spindle moulder
Caution!
The correct insert ring must be used when inserting the moulding tools.
The following images are depicted with no protective devices for improved visibility.
Use the prescribed protective devices when working!
Moulding the long side
Figure S
Guide the workpiece along the moulding fence
using the overhead roller guard assembly.
Use the power feed device if possible
-
(accessory: article no.: 6807 0000).
Safety note:
When using the power feed device, the distance from
the last feed roller and the wall should be at least
55cm longer than the workpiece.
Moulding the front end
Figure T
Guide the workpiece along the moulding fence
using the overhead roller guard assembly and the
guide rails.
- With the sliding table can be used to machine
a surface exactly perpendicular to the long
side.
Figure S
Figure T
Page 51