Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
min .........................minutes
or AC .............alternating current
or DC
....direct current
n o ...........................no load speed
...........................Class I Construction
(grounded)
...........................earthing terminal
..........................safety alert symbol
...........................Class II Construction
(double insulated)
.../min or rpm...revolutions or reciprocation
per minute
Wh ..........................Watt Hours
ASSEMBLY
WARNING:
repair the appliance
Charging the battery
WARNING:
charger.
•
Before first use, the battery must be charged for at least
6 hours.
•
Place the appliance on the charging base
it is not in use as shown in Figure B.
•
Plug the charger into any standard 120 Volt 60 Hz
electrical outlet.
WARNING:
empty all contents and dry thoroughly if needed to avoid
damage to your appliance.
•
Make sure the appliance is switched off. The battery will
not be charged when the on/off switch
position.
nOTE: While charging, the charger may become warm. This
is normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
Fig. B
WARNING:
at ambient temperatures below 39°F (4°C) or above
104°F (40°C).
Do not attempt to modify or
For use only with the supplied
7
whenever
Before charging, be sure to
1
is in the on
Do not charge the battery
USE
Switching on and off (Fig. G)
•
Figure g - To start, slide the On/Off switch
(i.e. "O"= Off, "I" = On).
•
To stop, slide the switch back.
•
Return the product to the charger immediately after use
so that it will be ready and fully charged for the next
use. Ensure that the product is fully engaged with the
charger base.
Fig. G
Cleaning and emptying the product
WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick empty
method and a thorough clean method.
For a quick empty (Fig. H, I)
•
Figure h - Press the dust bowl release button
handle and remove the dust bowl.
Fig. H
•
The top of the bowl is open when the bowl is removed
so that dust can be easy dumped without touching the
filter.
Figure i - Empty the dust from the bowl
•
•
To replace dust bowl, place it back onto the handle until
it "clicks" firmly into position.
For a more thorough cleaning, remove bowl as described below.
English
1
forward
1
Projectile/Respiratory Hazard:
2
on the
3
.
3
Publicité
Table des Matières
