Section 3: Programming With Easy-Set Logic - Orbit 04112 Manuel De L'utilisateur

5. Activate Battery
One Lithium CR2032 battery (included) is required to retain the
program in memory during power loss . Annual replacement is
recommended .
Remove the plastic strip to activate the pre-installed battery .
(See page 12 for battery replacement)
PROGRAM
RAIN DELAY
ET
Note: The battery alone will not operate the valves in your
sprinkler system. The sprinkler timer has a built-in transformer
that must be connected to an AC voltage source.
Section 3: Programming with
Easy-Set Logic
A note about multiple programs
Your sprinkler timer provides the flexibility of using 3
independent programs (A,B,C) . A program is where you
store all of your sprinkler settings . It consists of a group of
stations set to specific start times and run times . Multiple
programs allow you to run different valves on different days
with different run times . While many applications only require
one program (A), using multiple programs can be useful for
drip areas, newly planted lawn, or rotary sprinkler stations .
Using programs to group stations with similar water needs
will maximize irrigation efficiency .
Primary programming can be accomplished in just a few basic
steps .
Primary Programming
Press the [RESET] to clear any previous factory programming
1. Set Clock
• Turn dial to [SET CLOCK]
Remove plastic
strip to activate
battery
™
• Press the [+/–] buttons to set the current time of day
Tip: To increase or decrease more rapidly, hold down either the
[+] or [-] buttons until the display goes into rapid advance mode.
• Press the [   ] buttons to set am/pm
• Turn dial to accept time
2. Set Date
• Turn dial to [SET DATE]
• Y/M/D will appear (blinking letter indicates selection)
• Press the [+/–] buttons to set the correct year, then
press [ENTER] or [   ]
• Press the [+/–] buttons to set the correct month, then
press [ENTER]
• Press the [+/–] buttons to set the correct date
• Turn dial to accept date
3. Start time
• Turn dial to [START TIME]
• Press the [+/–] buttons to select time you'd like your
watering to begin
(time will adjust in 15 minute increments)
The display will show
Please note that [START TIME] is the time of day that your
programmed watering starts . You can set up to 4 start times .
All stations that have a programmed run time (how long) will
run in sequence at these times
Note: Start-Time Stacking
When a start time is set before the previous program has
completed, that start time will be "stacked" or delayed, and will
start upon completion of the previous program.
9