Orbit 04112 Manuel De L'utilisateur page 6

1. Select a Location
When choosing a location for your timer, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet (applicable only to U .S . retail timers)
• Ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius)
• Place it away from direct sunlight if possible
• Ensure at least 9" of space to the left of the sprinkler
timer box for the door to swing open after installation
• Locate the timer where there is easy access to sprinkler
wire (from valves) . If mounted in an outdoor location,
shut the compartment door to keep the timer safe
from weather damage . To lock: insert the key and turn
clockwise to the locked position
Note: Sprinkler timers are weather-resistant to UL-50 and ETL
Listings, but should not be placed in areas where continuous
water could cause damage.
6
2. Mount the Timer
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• Install a No . 8 screw (included) into wall in the upper
template location . Leave the screw head protruding 1/8"
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold
• Slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• Drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See figure 2
Figure 1: Use Mounting Template (included)
®
mounting holes
Figure 2: Hang timer on screw using keyhole
Keyhole
1/8"
No. 8 Screw
Wall
Pre-formed