Nissei DSK-1031 Instructions page 9

Put the cuff on your left arm with
AIR HOSE positioned toward your
hand.
Attach the cuff with hook and loop
fastener with the lower edge of the
cuff approximately 2 to 3 cm above
the inner elbow.
The cuff should fit snugly, leaving enough space for two fingers to
be put between your arm and the cuff.
If the cuff is wrapped more
tightly or loosely than this,
inaccurate blood pressure
readings may result.
Adjust the position of the cuff with
the scales on it. Position the cuff so
that the long scales are over the
brachial artery.
Press the surface of the cuff to
make sure that the hook and loop
fastens securely.
2 to 3 cm
ARTERY
ELBOW
Let your forearm rest naturally on the table and keep the cuff at the height of
2
your heart during measurement.
If the cuff is lower (higher) than the heart, the measured reading tends to
become higher (lower).
Take deep breaths and relax.
Do not move or speak while taking your
blood pressure.
Do not cross your legs during measurement.
Do not hold your breath.
3 TURN ON THE MONITOR.
Touch "START/STOP" KEY.
Air is exhausted from the cuff.
Automatic inflation starts.
CUFF SYMBOL is displayed.
Touch "START/STOP" KEY again to cancel measurement.
The monitor will exhaust air from the cuff and turn off.
-9-
SDG!DFG
SGLKSJPREJ
DKLFJGS
OGJOIER;J
DEFLATION
START/STOP
CUFF SYMBOL
See page 3.
SYMBOL
INFLATION
SYMBOL