Nissei DSK-1031 Instructions page 11

1 TOUCH MEMORY KEY.
Touch MEMORY KEY [1] to review readings saved in the memory bank [1] and
MEMORY KEY [2] to review those in the bank [2].
The average of the saved readings is displayed.
Note: Average will not be displayed unless
there are two or more readings saved.
2 TOUCH THE SAME MEMORY KEY AGAIN.
The latest reading saved in the selected bank
is displayed.
The display at the top shows memory number,
measurement date and time alternately. The
latest reading is displayed as memory "No. 1".
The results are recalled from the latest to the oldest with operation of MEMORY KEY.
The bigger memory number indicates the older number.
T R O U B L E S H O O T I N G
Blood pressure is extremely high or low.
???
Measurement is not taken with correct posture or the cuff is wrapped incorrectly.
Reconfirm the measurement procedures.
The reading was effected by moving or talking. Remain still and quiet
: Average
NUMBER OF SAVED RESULTS
-11-
SWITCHING MEMORY BANKS
Touching MEMORY KEY [2] at display of reading in the bank [1] will switch the display
to reading in bank [2] and touching MEMORY KEY [1] again will return to the display of
result in the bank [1].
3
TURN OFF THE MONITOR.
Touch "START/STOP" KEY.
Even if you do not turn off the monitor, it displays the result for approximately 30 seconds and
will turn off automatically.
DELETING SAVED READINGS
1
DISPLAY THE READING TO DELETE.
Display the average reading to delete entire readings in the memory.
2
TOUCH MEMORY KEY AND KEEP YOUR FINGER ON THE KEY.
Touch MEMORY KEY [1] to delete reading in the memory bank [1] or MEMORY KEY [2] to
delete reading in the bank [2].
The display will start flashing. Keep your finger on the key until the reading is replaced with
" ".
during measurement.
Measurement was taken right after exercise or other activities influencing the
reading. Measure again after resting for more than 5 minutes. See TIPS
ON TAKING YOUR BLOOD PRESSURE.