Husqvarna FS7000 D Manuel D'utilisation page 34

To do a check of the V-belts
• Pull and release the V-belts, 1 at a time. The belts
must give a long sound, not a short sound.
a) If you hear a long, clear sound from the V-belts,
the tension is correct.
b) If you hear only a short sound from the V-belts,
the tension is too low. Refer to
tension of the V-belts on page 34 .
• Examine the V-belts for wear and damages. Replace
damaged V-belts.
CAUTION: Do not replace only 1 of the
V-belts. Always replace all 4 V-belts at
the same time.
To increase the tension of the V-belts
CAUTION: The tension of new V-belts must
be increased after the first 2-4 hours of
operation.
1. Loosen the 2 bolts (A) with the blade shaft wrench.
B
A
2. Turn the bolts for the belt tension (B) clockwise until
the V-belts are tight.
CAUTION: Turn the 2 bolts for the belt
tension equally. The tension must be the
same in the 2 V-belts.
3. Do a check of the V-belts. Refer to
the V-belts on page 34 .
a) If the tension of the V-belts is too low, turn the
bolts for the belt tension some more.
b) Do this procedure again until the V-belt tension is
correct.
34
To increase the
B
A
To do a check of
4. Tighten the 2 bolts (A).
5. Loosen the bolts for the belt tension
counterclockwise approximately 1/16 of a turn.
1 /
16
CAUTION: Make sure that the 4 V-belts
have the same tension. Do not adjust the
tension of the V-belts too much.
To examine the wheels
• Examine the wheels for wear or damage. Replace
wheels and hubs if they are damaged or worn out.
• Examine if the rear wheel hubs and wheels are
loose. Tighten loose screws and nuts.
To do a check of the hydraulic oil level
1. Remove the plug in the inspection opening on the
hydraulic reservoir. Refer to
side (FS7000 D) on page 3 or Product overview,
right side (FS7000 DL) on page 5 for the hydraulic
reservoir position.
2. Make sure that the oil level is at the bottom edge of
the opening on the hydraulic reservoir.
1 /
16
Product overview, right
1223 - 002 - 09.07.2019