Husqvarna FS7000 D Manuel D'utilisation page 30

1. Make sure that the cutting blade is removed and that
the product is level when you examine the engine oil
level.
2. Remove the dipstick from the oil tank.
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick. Make sure that
the level of engine oil is between the marks on the
dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 44 for correct engine oil type.
To examine hoses and hose clamps
• Look for leakage on the hoses in the fuel system, the
hydraulic system and the cooling system.
• Examine the hoses for wear and damage, especially
where the hoses rub against other hoses or parts of
the product.
• Replace damaged hoses.
• Tighten loose hose clamps.
To clean the outer air filter
WARNING: Use approved respiratory
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filter is dangerous to your
health.
WARNING: Do not clean the air filter with
compressed air. This causes damage to the
air filter and the risk increases that you
breathe the dangerous dust.
It is not necessary to clean the inner air filter.
30
1. Examine the air filter indicator (A). If the air filter
2. Open the 3 clamps of the air filter housing and
3. Remove the air filter.
4. Tap the air filter against a hard surface or use a
5. Replace damaged gaskets.
Technical data
6. Examine the air filter hose and the hose clamps.
7. Install the outer air filter.
8. Install the air filter housing and close the 3 clamps of
To drain water from the gearbox
indicator is red, it is necessary to clean the outer air
filter.
remove the air filter housing.
vacuum cleaner to remove the particles.
CAUTION: Do not let the nozzle of the
vacuum cleaner touch the surface of the
air filter. Keep a small distance. The
sensitive surface of the air filter becomes
damaged if objects touch it.
a) Replace damaged parts.
b) Tighten loose clamps.
the air filter housing.
Note: If the 3 clamps of the air filter housing cannot
be closed, the outer air filter is not correctly installed.
CAUTION: Always replace a damaged air
filter, or the dust will go into the engine and
cause engine damage. Damage to the
engine because of a damaged air filter voids
the warranty.
CAUTION: Water in the gearbox can cause
corrosion and freeze damages.
A
1223 - 002 - 09.07.2019