Husqvarna FS7000 D Manuel D'utilisation page 12

4. To reset the safe mode, turn the engine start switch
to engine stop position (B) and then to ignition on
position (A).
A
Blade guard
The blade guard is a protective cover for the top part of
the cutting blade. It gives protection if parts from a
damaged cutting blade or other objects eject in the
direction of the operator. The blade guard prevents
injury from the cutting blade. The blade guard is also a
part of the water cooling system that keeps the cutting
blade cool during operation.
To do a check of the blade guard
• Make sure that the blade guard is correctly installed.
To install a blade guard (FS7000 D, FS7000
Refer to
DL, 20-42 in.) on page 18 or To install a blade
guard (FS7000 DL, 48-60 in.) on page 18 .
• Examine the blade guard for damages, such as
cracks.
• Replace a damaged blade guard.
• Replace the blade guard if it is hit, bent or has other
defects.
• Examine the blade guard lock for damages.
• Make sure that the blade guard lock is correctly
engaged.
Protective covers
Missing or damaged protective covers increase the risk
of injury on moving parts and hot surfaces.
To do a check of the protective covers
• Do a check of the protective covers before you
operate the product.
12
a) Front and right side:
B
b) Rear and left side:
• Make sure that the protective covers are correctly
attached and do not have cracks or other damages.
• Replace damaged protective covers.
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
To do a check of the muffler
• Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
WARNING: The muffler becomes very hot
during and after use and when the engine
operates at idle speed. Be careful near
flammable materials and/or fumes to prevent
fire.
CAUTION: Do not change the muffler. The
muffler is of DOC type and a part of
emissions compliance.
1223 - 002 - 09.07.2019